DuraTech Industries Haybuster 572, Operating Instructions And Parts Reference, Page: 43 / 160

33
5 7 2 R O U N D B A L E R O P E R A T I N G I N S T R U C T I O N S
5.2 CALIBRATION OF THE 572 BALER – General
1. Connect the PTO.
2. Connect the pickup lift hoses.
3. Connect the baler hoses.
4. Connect monitor.
5. Connect monitor to power outlet.
1. TWINE ARM CALIBRATION
1. With the tractor running and the hydraulic lever locked in detent allowing oil flow through the valve body,
press button #6 and check fault screen.
If there is a square box by
TWINE ARM FAULT
check electrical connection to cylinder before
proceeding further. If there is a square box by the TWINE ARM NO CAL follow steps 2-5. If there is no
square box by the
TWINE ARM NO CAL
skip to section 4.1. to test the calibration.
2. Press esc button to go to the menu screen. To select twine, press button #7 then press ESC to return to the
monitor screen.
3. To select manual, press button #4 if not already selected.
4. Using the left and right arrow buttons on the monitor, extend twine arms fully and hold for 3 seconds.
Retract twine arms fully and hold button for 3 seconds.
5. Now check fault screen, if there are no square boxes appearing for the twine arm calibration the twine
arm calibration is complete.
2. BALE SIZE CALIBRATION
1. With the tractor running and the hydraulic lever locked in detent allowing oil flow through the valve body,
check fault screen. If there is a square box by BALE SIZE FAULT , check electrical connection before
proceeding further. If there is a square box by the BALE SIZE NO CAL , follow steps 2‑3. If there is no
square box by BALE SIZE NO CAL skip to section 4.2 to test the calibration.
2. Press button on the orange box, open tailgate completely and continue holding the button for 3 seconds.
Close tailgate completely and continue holding for 3 seconds.
3. Now check the fault screen, if there is no square boxes appearing for the bale size calibration the
calibration is complete.