page 4 of 29
Duplomatic MS
S.p.A
. ▪
EDM-M*/30 Start-
up Manual ▪
89251/218
ETM ▪
Jun 2018
Features
The EDM-M is a digital card suitable for the control of one proportional valve with two
solenoids (M2 version) or one/two independent proportional valves, also pressure or throttle,
with one solenoid each (M1 and M3 versions).
It is designed for rail mounting type DIN EN 50022.
The card supplies the current to the solenoid according to the reference signal and
independently of temperature variations or load impedance.
The card uses micro USB interface, and via software EBC configurator it is possible to set
parameters.
-
100% compatible with previous version 20
-
Micro USB connector:
no serial converter required
optionally board supplied by USB for programming (valve use disabled)
-
Separate PWM settings (PWM-Dither) in the 2-channels version EDM-M3
-
Enable signal
(version A only)
-
Parameters programmable via software:
Ramps, deadband compensation, scaling of analogue inputs
-
Fault recognition (cable breaks, short-circuits, etc.)
