Spin Welder User’s Manual
Section 4 – Installation
Page 23
Page 22
Dukane Manual Part Number 403-547-03
Dukane Manual Part Number 403-547-03
detailed measurements of the fixture mounting holes
in the platen.
Compressed Air
The Spin Welder requires a clean, dry supply of
compressed air at a nominal pressure if 100 psi (6.9
bar). The air supply should be capable of delivering
1 SCFM and at least 80 psi (5.5 bar) and not greater
than 110 psi (7.6 bar). The air is attached to the rear
of the press using a standard 3/8” NPT fitting. The
location is shown in Figure 4–3. A sintered metal
diffuser is attached to the exhaust port directly below
the air connection. If your compressed air supply
contains any oil or moisture, you should attach a
pre–filter between the compressed air supply line
and the Spin Welder.
Control Cables
Base Interface Cable
Directly to the right of the compressed air exhaust
diffuser is the press control input connector (J8).
O
Figure 4–3
Compressed Air Connection
