Ducati Multistrada 1200S Pikes Peak, Owner'S Manual

Page: 125 / 278

LAP registration function
This function describes the "LAP" time registration.
If the function is activated (see "LAP activation/
deactivation description" page 120), the lap time can
be registered as follows:
-
the first time the flash is pressed (3) starts the
“lap timer” for the first lap and the instrument
panel shows the "START LAP" indication on the
round display (B) for 4 seconds and then returns
to the "previous" page;
- from this moment, each time that the flash is
pressed (3) the round display (B) automatically
shows the lap time for 10 seconds and then
returns to the "previous" page.
You can save a maximum of 30 laps in the memory.
Once the memory is full, the instrument panel no
longer stores lap times when the flash button (3) is
pressed, and the flashing message “LAP MEMORY
FULL” is shown on the round display for 3 seconds
until the times are reset. When the LAP function is
set disabled, the current "lap" is not stored. If the LAP
function is active and the motorcycle is suddenly
turned off (Key-Off), the function will be automatically
disabled (even if the lap timer was active, the current
"lap" is not stored).
If the time is never "stopped", it will roll over upon
reaching 9 minutes, 59 seconds and 99 hundredths;
the lap timer starts counting from 0 (zero) and will
keep running until the function is disabled. If,
however, the LAP function is switched on and the
memory has not been cleared, but fewer than 30 laps
have been saved (e.g. 18 laps), the Instrument panel
will store any remaining laps until the memory is full
(in this case, it will store an additional 12 laps).
This function only displays lap times being recorded;
but other data are also saved (MAX speed, MAX rpm,
rev limiter if reached) for viewing at a later time in the
Lap Memory function (stored LAPs viewing).
122