11
AFTER InSTALLATIon
Verify correct installation:
- Upon completion of installation, test to make sure that your door opening system is working correctly, and test
the safety system. The door must stop when it contacts an obstacle.
NOTE: CE safety rules. To be tested after installation and after each setting by a dynamometer
Max. pressure on obstacle: 400N and must decrease to max.100N within 0,75seconds and decrease to 0,0N
within 1 sec.( UNI EN 12453-EN12445)
This measurement must be taken and tested 30cm/10cm and 5 cm from closed gate position.
- The safety system could fail if the door opener is not correctly installed.
- Verify power adjustment and settings after installation.
- Ensure that the parts of the door do not extend over public foothpath or roads
- Install any fixed control at heigh of at least 1,5m and within sight of the door but away from mooving parts
- Make sur you have a second pedestrian access to your property. Remember: in case of power failure or othe
problem with your opener you might be unable to operate it from outside your property.
- Save the unlocking key in a safe place out of reach of childrens, in order to permit to manually unlock (from
inside) the gate and operate it manually in case of power failure or other problem.
- Ensure safety and prevent injuries:
- Place warning labels on the wall next to door control. permanently fix a label warning against entrapment in
a prominent place or just near any fixed control
- Without a properly working safety system, people (particularly small children) can be SERIOUSLY INJURED
or KILLED by a closing door. After installation ensure that the mechanism is properly adjusted and montly
verify
- Never permit anyone to cross the path of a closing garage door.
- No one should go close to a stopped, partially open door.
- Never leave children unsupervised near a door opener, whether moving, open, closed or stopped.
- Never permit children to play with the door opener’s remote control buttons or transmitters, and do not allow
children to use them to operate the door opener. Always keep remote controls out of reach of children.
- Install wall-mounted door controls (optional) out of the reach of children and away from moving parts of the
door.
- Always keep the door in sight until completely closed.
- While the door is closing, do not attempt to stop it by hand. This is extremely dangerous.
Prevent damage of the opening system and objects:
- Never leave cars, motorcycles or similar objects within the gate path, or in the dagerous zone indicated on
drawing.
- Do not attempt to drive into the gate path while the door is moving. Always wait until the door comes to a
complete stop.
- Activate the door only when it can be seen clearly, when it is properly adjusted and there are no obstructions
to door travel.
Maintain the opening system:
- Keep the door and the opening system properly maintained.
- Always turn OFF the power before performing any maintenance. Service the door and opening system
regularly. Regularly grease hinges and other appropriate moving parts.
Prevent damage of the opening system and objects:
- Never leave cars, motorcycles or similar objects within the gate path, or in the dagerous zone indicated on
drawing.
- Do not attempt to drive into the gate path while the door is moving. Always wait until the door comes to a
complete stop.
- Activate the door only when it can be seen clearly, when it is properly adjusted and there are no obstructions
to door travel.
Maintain the opening system:
- Keep the door and the opening system properly maintained.
- Always turn OFF the power before performing any maintenance. Service the door and opening system
regularly. Regularly grease hinges and other appropriate moving parts.
USEFUL InSTALLATIon ACCESSoRIES
before installation provide yourself with following accessories:
Rubber hammer, level, screwdrivers, wrenches, cables, clamps, conduit for the passage of cables, self-drilling