Ducati Hypermotard 950, Owner'S Manual

Page: 99 / 288

DQS indicator - accessory
If DQS is installed, the instrument panel displays
DQS status as follows:
●
if DQS system is enabled, the indication to
engage the gears DQS U/D" is displayed;
●
if DQS system is in reduced performance mode,
the indication to engage the gears "DQS U/D" is
displayed flashing;
●
if the DQS system or the control unit is in fault,
the “DQS Err” message is displayed in red;
●
if DQS system is disabled, "DQS OFF" is
displayed.
The DQS with up/down feature allows the rider to
upshift and downshift without using the clutch lever.
It includes a two-way microswitch - built in the lever
mechanism - that outputs a signal to the engine
control unit whenever the gearshift is operated.
The system works in a different way when upshifting
and downshifting.
Here below are some tips that will ensure you
properly exploit this feature:
●
The Ducati Quick Shift takes the same shift lever
operation as with vehicle not equipped with the
Ducati Quick Shift.
Ducati Quick Shift is not designed for shifting
automatically.
●
For any gearshift request (upshifting or
downshifting) the rider has to move the shift
lever from its idle position in the desired
direction against the force of the spring through
a certain over-travel, then keep the shift lever in
this position until the gearshift is completed.
Once the gearshift has been completed, the
lever has to be fully released in order to allow
another gearshift acted by Ducati Quick Shift. If
the rider does not move the shift lever up to end
DQS
1
3
90
2
3
4
5
6
7
8
9
10
11
10:34
AM
DTC 5
U/D
ABS 1
DWC
RPM X 1000
km/h
km TOT
5260
40
°C
TOURING Gear
1
Fig 60
98