Appendix 3: Regulatory Information
l
Wireless Supervision window shall be set to 4 hours for Fire Installations (refer to Installer portal > Panel Set-
tings>Panel Configuration>Comms Configuration > Ethernet Supervision, Cellular Supervision)
l
Wireless Supervision window shall be set to 24h for Burglary Installations only (refer to Installer portal > Panel Set-
tings>Panel Configuration>Comms Configuration > Ethernet Supervision, Cellular Supervision)
l
RF Jam detection shall be enabled (refer to Installer portal > Panel Settings>Panel Configuration>System Con-
figuration> RF Jam Detection and Reporting)
l
Bells will be active During 2-way Audio (refer to Installer portal > Panel Settings > Panel Configuration > System Con-
figuration > Wireless Siren Control)
l
New Alarms will Disconnect 2-way Audio (refer to Installer portal > Panel Settings > Panel Configuration > System
Configuration > New Alarms Disconnect 2-way Audio for 2G)
l
When the 2- way audio feature is enabled(refer to Installer portal > Panel Settings > Zones > 2-Way Audio) ensure
that New alarms will not Disconnect 2-Way Audio is OFF and Wireless Siren During 2-Way Audio is ON
Programming
The notes in the programming sections describing the system configurations for UL/ULC listed installations shall be imple-
mented.
Bell Location
The alarm sounding device (bell) shall be located where it can be heard by the person operating the security system during
the daily arming and disarming cycle.
Casual Users
The installer should caution the user(s) not to give system information (e.g., codes, bypass methods, etc.) to casual users
(baby-sitters or service people).
User Information
The installer should advise the users and note in the User’s Manual:
l
Service organization name and telephone number
l
The programmed exit time
l
The programmed entry time
l
Test system weekly
Regulatory Agency Statements
FCC MODIFICATION STATEMENT
Digital Security Controls has not approved any changes or modifications to this device by the user. Any changes or modi-
fications could void the user’s authority to operate the equipment.
Digital Security Controls n’approuve aucune modification apportée à l’appareil par l’utilisateur, quelle qu’en soit la nature.
Tout changement ou modification peuvent annuler le droit d’utilisation de l’appareil par l’utilisateur.
ISED CANADA INTERFERENCE STATEMENT
This device complies with Part 15 of the FCC Rules and ISED Canada licence-exempt RSS standard(s). Operation is sub-
ject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any inter-
ference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'ISED Canada applicables aux appareils radio exempts de licence. L'ex-
ploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur
de l'appareil doit accepter tout brouillage radioélectrique subi, ême si le brouillage est susceptible d'en compromettre le
fonctionnement.
FCC CLASS B DIGITAL DEVICE NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
- 58 -
