Section 4: Programming Options
Zone Attribute
This section is used to customize zone behavior for the
device. The table below specifies the status of each attribute
for this device.
See on page 43 for attribute definitions.
Door Chime
Disabled
Alarm Report
Enabled
Burglary Verified
Enabled
Transmission Delay
Enabled
Bell Audible
Enabled (read-only)
Bell Steady
Enabled (read-only)
Bypass Enable
Enabled (read-only)
Force Arm
Disabled (read-only)
Swinger Shutdown
Enabled (read-only)
Two Way Audio
Enabled (read-only)
Talk Listen
Enabled (read-only)
Supervision
This option is used to enable/disable wireless supervision of
the device. Supervision monitors the presence of the wire-
less device on the alarm system.
Default:
Enabled
Valid range:
Enabled/Disabled
Alarm LED
This option is used to enable/disable the device’s onboard
LED. When enabled, the LED activates when an alarm
occurs.
Default:
Enabled
Valid range:
Enabled/Disabled
24 Hour PIR
This option is used to define if motion alarms are always
enabled or only enabled at night. For UL/ULC installations,
night mode is to be used to supplement protection of the
detection area.
Default:
Enabled
Valid range:
Enabled/Disabled
High Traffic Shutdown
Activating this feature helps conserve battery power when
the system is disarmed by configuring a reporting timer.
When motion is detected, the device transmits an alarm to
the receiver and does not report any further events until the
timer expires. Any motion detected during the configured
period is reported onece the timer expires. No Delay causes
the device to report an alarm each time the detector is
tripped.
Default: Not Active
Valid
range:
Not Active, No Delay, 5 Second Delay, 15 Second Delay, 30
Second Delay, 1 Minute Delay, 5 Minute Delay, 10 Minute
Delay, 20 Minute Delay, 60 Minute Delay
Detection Range
This option is used to select the sensitivity of the detector.
The higher the sensitivity, the further the range of the
detector.
Default:
High
Valid range:
Low, High, UL
4.6.11 Wireless Door Window Con-
figurations
The following sections are used to program wireless
door/window contacts.
Device Label
This option is used to program a custom label for the wire-
less device.
Default:
Zone ZZZ
Valid range:
32 character ASCII
Device Enable/Disable
This option is used to enable and disable the wireless
device.
Default:
Enabled
Valid range:
Enabled/Disabled
Zone Type
This option is used to program a zone type for the device.
Default: 24-hour Temperature
Valid
range:
Delay 1, Delay 2, Instant (Perimeter), Interior Follower,
Interior Stay/Away, Delay Stay/Away, Day Zone, 24Hour
Burglary, 24Hour Silent Holdup, 24Hour Audible Panic,
24Hour Medical Alarm, 24Hour Supervisory Buzzer, 24Hour
Non-Alarm
Device Partition Assignment
This option is used to enable and disable the wireless
device.
- 39 -
