WatchMaster
®
IP Elite User Manual
14
4.5
ASSEMBLY
1.
Using 8 of the #6 screws, assemble the Base Mount, to the IP Camera. Tighten the 8
fasteners to approximately 10 in-lbs. of torque with the Electric Screw Driver, and T10
Security bit.
2.
Using 4 of the #6 screws, assemble the optional Standard 4 hole Mount, to the Base
Mount, and tighten the fasteners to approximately 10 in-lbs. of torque with the Electric
Screw Driver, and T10 Security bit.
3.
Connect the cable(s) to the respective connector:
a.
Ethernet: Ethernet Port
b.
Analog: Analog Video Out (IP Elite 3000 only)
c.
AC/DC Power: Connect wires to power block according the pin-outs below
Figure 10: IP Elite 3000 Pin-Out
Pins 1-3: Power (GND, 24V AC, 12-24 DC/24V AC)
Pins 4-5: RS-485 (POS, NEG)
Figure 11: IP Elite Pin-Out (24V AC, 24V AC, 12V DC, GND)
d. RS-485: Connect wires to power block according to the previous pin-outs (IP Elite
3000 only)
4.
Reconnect Power to the existing cable(s).
