WatchMaster
®
IP Elite User Manual
5
Figure 2 and Table 2 below describe the details of the rear of the camera.
Figure 2: IP Elite 3000 Camera Rear View
Table 2: Camera LED Indicators
Item
Description
Network Port
Accepts a standard LAN cable to connect the IP camera to a
10/100Base Switch or Router.
LED
Indicates information about the network connections as follows:
Off
– LAN connection is NOT detected
Solid Green - 100 MB LAN connection is detected
Solid Amber - 10 MB LAN connection is detected
Flashing Green/Amber - Data is being transmitted or received via
the LAN connection
Analog Video Connector
Accepts a standard BNC terminated coax cable for analog video
output. A 90-degree BNC adapter is also pre-installed on the
camera (not pictured above).
Power/RS-485 Connector
5-pin terminal block for power input
– 2 for AC power input, 1 for
DC power input, 1 for Ground, and 2 for RS-485 connections.
12-24V DC or 24V AC power with minimum 13W or 0.54A and
10% tolerance.
Factory Reset Button
Reset button reboots the IP camera and resets it to the factory
default state. You can use a pin or paper clip to depress it and
hold for at least 6 seconds.
