FULL USER MANUAL
GANNET 2+ / MAX +
19
18
•
When removing the battery, pull gently on the connector whilst wiggling it,
do
not jerk or pull on the wires only,
•
Add a bit of lubricant to the landing gear retaining rubbers from time to time, it
helps them slide in easier locking them in place.
•
If landed in water where there is a temperature variation the drone may draw
water into the flight bladder, when this happens altitude control may be
temporarily affected whilst the water runs out of the bladder, if this happens
take some care with manual altitude control till it is restored, the drone can be
stood nose up to aid the draining process of the bladder.
•
NEVER attempt hand catching the drone as a novice pilot,
the large carbon
propellers are extremely dangerous and can inflict serious injury.
•
Always stand well clear of the drone when taking off and landing
•
NEVER fly the drone over people especially not whilst carrying any load
If water landing does occur
Place drone nose up in a horizontal position on a level surface with battery hatch
and battery removed, this will aid in draining water from the flight bladder.
Drone Components & Light Status Drone Components & Light Status Drone Components & Light Status
Drone Components & Light Status
[ 1 ] Carbon Fibre propeller
[ 6 ] Waterproof Brushless Motor
[ 2 ] On/Off Button
[ 7 ] Rubber Foot
[ 3 ] Flight Indication Lights
[ 8 ] LED Status Indicator
[ 4 ] Payload Release
[ 9 ] Rear Hatch
[ 5 ] Landing Gear
[ 10 ] Rear Hatch Thumb Screw
Light Status Modes
Medium Yellow flash
No RC Connected / No GPS
Slow Light Green flash
Drone in Start-Up Self Check Mode.
Slow Dark Green Flash
GPS Mode
Ready to Fly
Blue Red Flash
Compass Calibration Mode
