FULL USER MANUAL
GANNET 2+ / MAX +
49
48
Explanation of Buttons
‘STOP” button
It is used to stop the process or go back to the previous step.
“Dec./-” button
It is used to go through the menus and decreased the parameter value.
“Inc./+” button
It is used to go through the menus and increase the parameter value.
“START” button
It is used to enter parameter or start program.
When you want to alter the parameter value in the program, press the START/
ENTER button to make it blink and then change the value by pressing DEC and
INC button. The value will be stopped by re-pressing the START/ENTER button.
I there is another parameter which can be altered in the same screen, on
confirming the first parameter value, the next parameter value will start to blink
and you can set it.
When you are ready to start to program, press and hold the START/ENTER button
for 3 seconds.
When you want to stop the program or go back to the previous step/screen, press
the BATT PROG/STOP button once.
Here are the detailed procedures to make the charger work. All the screens and
operations will take LiPo-CHARGE program for example
Connection
Ensure to connect the battery to balance port when charging LiPo, LiIon, LiFe and
LiHV battery under balance mode.
OPERATION PROGRAM
1.
Connecting to Power Source
2.
Connecting the Battery
3.
Balance Socket
Gannet Charger comes with the built in switching power supply. You can connect
the AC power cord directly to the main AC socket (100-240V AC) or attaching
directly to 12V car batteries. It is critically important that you use a fully charged
13.8V car battery.
Important!!! Before connecting a battery it is absolutely essential to check one last
time that you have set the parameters correctly. If the settings are incorrect, the
battery may be damaged, and could even burst into flames or explode.
To avoid short circuits between the banana plugs, always connect the charge
leads to the charger first, and only then to the battery. Reverse the sequence
when disconnecting the pack.
The balance wire attached to the battery must be connected to the charger
with the negative marking. Take care to maintain correct polarity!(See the wiring
diagram below.)
This diagram shows the correct way to connect your battery to the AC while
charging in the balance charge program mode only