FULL USER MANUAL
GANNET 2+ / MAX +
53
52
Error Message
Error Message
Incorrect polarity connected.
Charger and battery connection is wrong.
Input short circuit
Input voltage less than required value
Battery total voltage is lower than setting value,
please check the cell count.
Battery total voltage is higher than setting value,
please check the cell count.
Voltage of one cell in the battery pack is too low.
Voltage of one cell in the battery pack is too high.
The battery balance connection is wrong.
Please check the connector and cable.
Temperature too high, please check the temperature
sensor and take cooling measures.
22
Charging Procedure Quick Guide
5000 LiPo (4s)
Select Program (LiPo) -> Press Start
Select Balance Charge -> Press Start
Input Cell Count (4s) -> Press Start
Select Current (5000 mAh) -> Press Start
Select Charge Current (Max 5.5A) -> Press Start Press and hold Start for 2
Seconds
6600 LiHV (6s)
Select Program (LiHV) -> Press Start
Select Balance Charge -> Press Start
Input Cell Count (6s) -> Press Start
Select Current (6600 mAh) -> Press Start
Select Charge Current (Max 5.5A) -> Press Start Press and hold Start for 2
Seconds
8000 LiHV (4s)
Select Program (LiHV) -> Press Start
Select Balance Charge -> Press Start
Input Cell Count (4s) -> Press Start
Select Current (8000 mAh) -> Press Start
Select Charge Current (Max 5.5A) -> Press Start Press and hold Start for 2
Seconds
Charging the remote
Use a 5volt USB Power adapter and lead (supplied in Gannet Kit) to plug in and
charge the remote controller.
Do not charge your remote with a charger rated above 5V
