FULL USER MANUAL
GANNET 2+ / MAX +
51
50
Operation Program
BATT/PROGRAM Select
Press “STOP” and “-“to go through all the programs
and press “START/ENTER to enter LiPo BATT program.
Mode Select
Press “+” and “-” to go through all the modes (balance
charge mode,storage mode, discharge mode and fast
charge mode).
Battery Setting
Press START, the present value will start to blink. Press
”+” and ”-” to set the battery cells. And press START to
confirm your setting. At the same time, Press START,
the present value will start to blink. Press “+”and “-“to
change the value and press START to confirm your
setting. Charger automatically recommend charging
current according the capacity and cell count setting
value, Press START to confirm if no objection, or
manually set the current by pressing “+”or”-“button,
then press START to confirm.
Program Start
Press and hold START for 2 seconds to start the
program
Charging Status
It show the real-time data during charging.
1. Standby
After the charger is powered on, it will enter standby
mode. Connect the battery and the balance port. The
charger will automatically detect the connected battery
type.
2. Charging Current selection
After entering the main interface, you can press the
“INC” and “DEC” buttons to set the charging current
value. Check that the selected current does not exceed
the battery specifications. Then press the “START”
button to confirm the set value.
If there is no action in 10 seconds the program will
automatically recommend a charging current according
to the number of cells and capacity. The 10 second
countdown will be displayed in the lower left corner of
the current setting interface. The settings buttons will
reset the countdown timer.
3. Start charging
Press and hold the “START” button for 2 seconds to
start the charging program. When in charging mode, the
“INC”, “DEC” and “ENT” buttons are not available. Press
the “ESC” to stop charging.
Charge Programme
