DResearch – User Manual TeleObserver MR3180
2011-02-03
21
2.4.4
Video Out 1 and 2 – connection of control monitors
Two control monitors for monitoring the cameras can be connected in parallel via the recorder’s
analogue video outputs. This enables the camera pictures to be viewed in two different locations.
The cameras to be displayed on the monitors can be configured in the SystemManagement software
module. All 8 analogue and up to 12 IP cameras can be displayed using a video switcher and/or in
multi-view (single, quad, nona etc.). The position of the individual camera signals/video pictures within
the screen and the switching sequence can be individually configured.
It is not necessary for the relevant camera to be activated for recording in order to display video
pictures. Although only 8 IP cameras can be activated for recording, up to 12 IP cameras can be
connected to the recorder via the external switch and all 12 video signals can be displayed.
Please note that displaying video makes additional demands on the device. Too many video
signals can lead to reduced frame rates and hesitation in playback on the video OUT. Because of
this only set those cameras for video OUT which are absolutely necessary. Usually it makes
sense only to set up those cameras which cover sensitive areas (vehicle entry area or rear view
camera).
A suitable monitor is available directly from DResearch. Please look at our current product catalogue
or contact us.
2.4.4.1
Sequential video output and multiviews
Live pictures from the linked cameras can be switched through in sequence to be shown on the
control monitor – this is controlled via a digital input. Configuration is dealt with in full in chapter 3.
