84 of 95
Reference Manual ATOM one SSM500
and
gain_red
command description). Any subsequent play command with the same
buffer_id will not restore these settings, that means you can change the
wb_preset
and
R/G/B gains while playback is running. Stopping the playback with the
stop
command or
calling the
play
command with a different buffer_id will reset the settings to the stored
values again.
Parameter Minimal
Maximal
Comment
buffer_id
1
Depends on buffer count
(see
count
command)
Buffer which shall be played back,
playback starts at mark_in position.
speed
(optional)
-1000
1000
Playback speed. Divide by 10 to get
the playback factor (see examples
below). If no speed is specified a
factor of x1 (speed = 10) is used.
frame
(optional)
0
Depends on amount of
frames in buffer
Frame where playback is started.
If not specified or 0, playback will
start from the “mark_in” frame (if
buffer is “used”) or the current frame
(if buffer is “paused”). Otherwise it
will start at the given frame.
If the given frame is bigger than the
amount of frames in the buffer,
playback will start from the last
frame in loop mode, or jump to the
last frame and pause there in once
mode.
