39 of 95
Reference Manual ATOM one SSM500
1
Profile for the newer, improved IR-cut filter that was shipped with later
batches of ATOM one SSM 500 cameras.
When being shipped each camera is already configured with the correct calibration profile,
and the setting will survive a firmware update. This means usually you do not have to
setup the profile yourself. If you have a camera with an older model filter and buy a filter
upgrade from Dream Chip you should change the calibration profile for best color
reproduction.
If you are unsure about this setting, contact the Dream Chip technical support.
8.30 volatile <value>
This command is intended to be used by system integrators.
It can be used to set a 32 Bit unsigned variable to any value. The variable will keep its
value until a reboot is performed, then it is reset to 0.
This can for an example be used to detect if the camera has performed a reboot by setting
it to a non-0 value after boot.
Parameter
Value after Boot
Minimal
Maximal
value
0
0
4294967295