86 of 95
Reference Manual ATOM one SSM500
Note:
To check if the end of the buffer was reached in “once” mode, use the
play
command. If playback stopped, it will report a speed of 0.
Parameter
Value
Function
Comment
Mode
0
Loop
When reaching the mark_out position jump to the
mark_in position and continue playback.
1
Once
When reaching the mark_out position stop playback
and repeat the last frame.
17.8 pause
Pause the current playback. The current frame will be repeated to produce a still frame.
17.9 stop
Stop playback from current buffer.
Depending on the stop mode (see
stop_mode
command below) the playback output will
then switch to live playback or a test pattern.
17.10
stop_mode <mode>
The stop mode defines the behavior of the camera when playback is stopped (see
stop
command above).
When stop is set the camera can either output the live image or two kinds of test pattern
(black image or color bars).
Parameter
Value
Function
Comment
Mode
0
Live
Show live image when stop is called.
1
Black
Show black image when stop is called.
2
Color Bars
Show test image (color bars) when stop is called.
17.11
pos
Print the frame position in the current playback buffer. This command can be queried
during playback to show the playback progress.
If no buffer is currently being played, the returned position will be 0.
To see the current range of frames being played back use the
status
and
mark_pos
commands.
17.12
seek <mode> <pos> <ret_pos>
Seek to another frame in the current buffer. Depending on the given mode a relative jump
counted from the current position is done or an absolute jump inside the buffer is
performed.
The <ret_pos> parameter is optional. If it is set to 0 or not specified the seek is executed
and “OK” is returned upon completion. If it is set to 1 after the seek was performed the new
