Vigor3200 Series User’s Guide
6
1
1
.
.
3
3
H
H
a
a
r
r
d
d
w
w
a
a
r
r
e
e
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
Before starting to configure the router, you have to connect your devices correctly.
1.
Connect the cable Modem/DSL Modem/Media Converter to any WAN port of router
with Ethernet cable (RJ-45).
2.
Connect one end of an Ethernet cable (RJ-45) to the
LAN
port of the router and the other
end of the cable (RJ-45) into the Ethernet port on your computer. Or, use a switch to
connect Vigor router and computer(s).
3.
Connect one end of the power adapter to the router’s power port on the rear panel, and
the other side into a wall outlet.
4.
Power on the device by pressing down the power switch on the rear panel.
5.
The system starts to initiate. After completing the system test, the
ACT
LED will light
up and start blinking.
(For the detailed information of LED status, please refer to section 1.1.)
Summary of Contents for Vigor3200 Series
