DragonWave AirPair 100-UL, Product Manual, Page: 91 / 130

83 Appendix C – Command Line Interface (CLI)
83
Command Steps
Exit Exits the current telnet session. The exit command terminates the
user’s telnet session on the user’s PC as well. If the user types the
command ‘lo’ while connected to CLI using telnet as the transport
mechanism, the telnet session does NOT terminate on the AirPair.
The resources on AirPair to support the telnet session are still in
use.
Sequence:
exit press Enter
get alarms
Shows the alarms that are present in the system.
Sequence:
get alarms press Enter
The system responds with (example):
--Interface Card:
No alarms
Auto-Negotiation Failure: Mismatched Duplex
--modem Card:
No alarms
Loss of signal lock from demodulator
SNR threshold exceeded
Modulator PLL lock failure
Modulator Loss of sync bytes
Modulator Input FIFO overrun/overrun
Modulator Data inactivity
Frequency Not Selected.
--Radio:
No alarms.
PLDRO Lost Lock alarm
Radio Lost Communication alarm
Radio Mismatch alarm
--IF:
TX Synthesizer Unlocked
RX Synthesizer Unlocked
Version 2.0