DragonWave AirPair 100-UL, Product Manual

Page: 111 / 130

103 Appendix C – Command Line Interface (CLI)
103
Command Steps
get transmit power Displays the transmit power level for the system.
Sequence:
get transmit power press Enter
The system responds:
System is programmed and transmitting at [powerLevel] dBm.
where
[powerLevel] is in the range –99 .. 99.
Note: RF Power displayed is displayed in multiples of 10, e.g., 132
dBm represents 13.2 dBm.
If the radio is not connected, the system responds:
System programmed to [powerLevel] dBm. Radio communication
has not been established. System not transmitting.
where
System will transmit at [powerLevel] dBm when radio communication
has been re-established.
get unique peer
authentication key Displays the serial number of the system that this AirPair
communicates with in UNIQUE authentication mode.
Sequence:
get unique peer authentication key press Enter
The system responds:
uniquePeerAuthenticationKey: [serial number of peer]
Version 2.0