DragonWave AirPair 100-UL, Product Manual, Page: 90 / 130

82
Dragon Wave
Command Steps
delete mib [newest/both] Deletes the MIB. If you delete the newest MIB, then the old
becomes the active MIB. If you delete both MIBs, the default MIB
is created on system startup. There are two copies of the MIB in
FLASH.
Note : Do not delete both MIBs. The MIBs contain all system
settings, e.g., frequency, SNMP settings. If you delete both MIBs,
the AirPair loses communication.
Sequence:
Type delete mib <newest/both> press Enter
The system responds:
Delete MIB [Newest/Both]?
To delete both MIBs:
Type
Y press Enter
To cancel the delete action:
Enter
N press Enter
The system responds:
Are you absolutely sure? Enter Y (yes) or N (no):
To delete the MIBs:
Enter
Y press Enter
To cancel the delete action:
Enter
N press Enter
Note : The system does not allow you to enter any commands until
the MIB has been deleted, or has failed to delete.
When the system successfully completes the command, it displays
the message:
Delete [Newest/Both] MIB [OK/Failed/Cancelled]
AirPair 100 UL 24 GHz Product Manual