DragonWave AirPair 100-UL, Product Manual

Page: 125 / 130

117 Appendix C – Command Line Interface (CLI)
117
Command Steps
set user Establishes the user account. Ten is the maximum number of
characters for a username. After you have set up the user
account, log out and log in again with the new username.
sequence:
set user press Enter
UserName :
<username> press Enter
Verify UserName:
<username> press Enter
Password:
<*****> press Enter
Verify Password:
<*****> press Enter
User accepted.
set unique peer
authentication key [serial
number of peer] Stores the serial number of the AirPair that the system will be
communicating with.
Sequence:
set unique peer authentication key [serial number of peer] press
Enter
where
[serial number of peer] is the serial number of the peer
The system responds:
uniquePeerAuthenticationKey: [serial number of peer]
Note: This value only applies when the peerAuthenicationMode is
UNIQUE.
set ip address
[123.123.123.123] Sets the IP address used for the system. This is an NOC level
command.
Sequence:
set ip address [123.123.123.123] press Enter
where
[123.123.123.123] is in decimal dot notation.
The system responds:
System IP address: [123.123.123.123]
Version 2.0