DragonWave AirPair 100-UL, Product Manual, Page: 116 / 130

108
Dragon Wave
Command Steps
reset system Resets the system to save the setting to FLASH and restart the
system with the new settings taking effect.
Sequence:
reset system press Enter
The system responds:
system reset.
save mib Saves the MIB to RAM. Perform this command save setting
changes to FLASH. This command does not restart the system
and does not put any new settings into effect. A system reset
command will cause settings in RAM to be programmed into
FLASH. Executing a system reset command will result in the new
settings to take effect.
Sequence:
save mib press Enter
The system responds:
MIB saved successfully.
set air interface
authentication type
[none/unique/group] Sets the authentication type.
Sequence:
set air interface authentication type [none/unique/group] press Enter
Where
[none/unique/group] is one of the available authentication types.
The system responds:
air interface authentication type set to [authentication type]
set authentication failure
[block_traffic/pass_traffic
] Configures the action to take on peer authentication failure.
Sequence:
set authentication failure [block_traffic/pass_traffic] press Enter
The system responds:
System will [action] on peer authentication failure.
where
[action] is block_traffic or pass_traffic.
AirPair 100 UL 24 GHz Product Manual