DragonWave AirPair 100-UL, Product Manual

Page: 123 / 130

115 Appendix C – Command Line Interface (CLI)
115
Command Steps
set snmp trap [trapIndex]
[enable/disable] Sets the SNMP trap and enable or disable it.
Sequence:
set snmp trap [trapIndex] [enable/disable] press Enter
The system responds:
Trap# TrapName Enabled(Yes | No)
1 ColdStart No
2 WarmStart No
3 Link down No
4 Link up No
5 Explicit Authentication Failure No
6 AutoNeg Mismatched Duplex No
7 LossOfSignalLockFromDemod No
8 BerThresholdExceeded No
9 Mod PLL lock failure No
10 Mod loss of sync bytes No
11 Mod input FIFO overrun/underrun No
12 Mod input data inactivity No
13 SNR below threshold No
14 PLDRO lost lock No
15 Radio lost comm No
16 Radio mismatch No
17 IF Tx Synth Unlocked No
18 IF Rx Synth Unlocked No
Version 2.0