DPS Telecom D-PK-NGDLT, User Manual

Page: 44 / 86

38
System 12.1
From the Provisioning > System menu, you will configure and edit the global system, call, T/Mon and control
settings for the NetGuardian LT G2.
Fig.12.1.1 The Provisioning > System menu
Global System Settings
Name
A name for this NetGuardian LT G2.
Location
The location of this NetGuardian LT G2.
Contact
Contact telephone number for the person responsible for this NetGuardian LT G2.
"From" Email Address
A valid email address used by the NetGuardian LT G2 for sending email alarm
notifications.
DTMF Pass Code
Used to login to the unit via telephone to hear alarm notifications. Only number
entries are valid.
DTMF Record Pass
Code
Needed to access rights to record or re-record the custom (voice) alarm detail.
Only number entries are valid.
Rings Before Pickup
Used to change the number of rings before the unit picks up when dialing into it.
Announce Alarms/
Clears during call
Check this box to receive an audible notification if the alarm state changes during a
call.
Only Allow Momentary
Relay Operation During
Call
While in the Operate Relays voice menu, you will not be prompted for voice
DTMF commands for latching or releasing relays, and only a voice command to
Momentarily Operate Relay will be given.
TRIP Unit ID
The site number to use when communicating over dialup to T/Mon
DCP Responder Settings (For use with T/Mon)
DCP Unit ID / Protocol
User-definable ID number for this NetGuardian LT G2 (DCP Address) and desired
protocol.
DCP over LAN Port /
Protocol
Enter the DCP port for this NetGuardian LT G2 (UDP/TCP port) and desired
protocol.
Analogs and Sensors History