DPS Telecom D-PK-NGDLT, User Manual

Page: 16 / 86

10
5.2.2 Craft Port
The back panel craft port is primarily used to give the NetGuardian LT G2 an IP address so you can continue the
rest of your database configuration over LAN. Use a terminal emulating software program like HyperTerminal to
enter the NetGuardian LT G2's TTY interface. Please see the Quick Start section for instructions.
5.2.3 LAN Connection
Fig. 5.2.3 LAN Connection Pinnout
LAN is used for web browsing to the NetGuardian LT G2. You can also do your databasing over LAN, as well as
sending email notifications and SNMP traps. To connect the NetGuardian LT G2 to the LAN, insert a standard
RJ45 Ethernet cable into the 10/100BaseT Ethernet port on the back of the unit. If the LAN connection is OK, the
LNK LED will light
SOLID GREEN .
5.2.4 Modem Connection
Fig. 5.2.4 Modem Connection Pinnout
The NetGuardian LT G2's Modem connection is used for voice or TRIP notifications. The rear panel modem jack
connects the NetGuardian LT G2 to a standard telephone line. This will allow you to dial in / dial out from the unit.
5.2.5 Temperature Sensor
Fig. 5.2.5 Temperature sensor