68
Crane 2000LE and 3000LE
05-2021
DL6001-003
Crane 2000LE and 3000LE Wiring, Setup and Troubleshooting
In-ground Motion Assist 360 drive with Remote Control Enclosure
Chapter 19
19.1 Install outer section container lids
45.2.1 Install outer section container lids.
WARNING
Program switch must be in Off
position.
WARNING
Press an Emergency Stop
pushbutton.
TIPS AND RECOMMENDATIONS
Wings not shown to provide detail
on lid fastening.
1. Place foam rubber seal on each side of
container lid center section(Fig. 19.1.4).
• Seal has adhesive backing.
• Seals must be placed directly against
center section container lid flange as
shown in Fig. 19.1.6. This will allow proper
installation of outer section container lids
and installation of flat head screws (13).
2. Install two outer section container lids
using fastener hardware in Fig. 19.1.3.
CAUTION
Insure flange gasket (
8
) is intact
and holes line up with holes in
in-ground container flange.
Fig. 19.1.1
Outer section container lid
5
Outer section container
lid DS6033
Fig. 19.1.2 Foam rubber seal
6
Foam rubber seal,
3/8" wide x 7/32" high
acrylic adhesive backing
29" minimum length
DC6047
5
Fig. 19.1.3 Container lid fastener hardware
13
1/4-20 x 3/4" sealing
flat head screw
DF6025-01G
13
5
5
Fig. 19.1.5 Container lids installed
6
Foam rubber seal, 29"
minimum length
DC6047
7
Container lid center
section DC6049
8
Flange gasket DC6046
Fig. 19.1.4 Foam rubber seals installed
5
Outer section container
lid DC6027
13
1/4-20 x 3/4" sealing
flat head screw
DF6025-01G
19 Install in-ground container covers
6
6
7
8
13
6
