DPM-OTR
Version 1
2019-01-28
9
6)
Once the tire serial number has been programmed successfully, a new position will
be highlighted to input another sensor serial number. Continue to program the
remaining sensors by repeating the above steps 4 and 5.
7)
Once all sensors have been programmed, press the “P” button momentarily to move
to the Baseline Pressure Settings. The monitor will now display the screen shown in
Figure 2-7. Note, press and hold “P” for 5 seconds to exit programming mode and
return to normal operating mode at any time.
B.
BASELINE PRESSURE PROGRAMMING
NOTE: To enter into Baseline Pressure Programming Mode
from the Normal Operation Screen, press and hold the “P”
button for 5 seconds until the “PROGRAM” screen is
displayed. Then press the “P” button once to access the
Baseline Pressure Programming screen “PRESSURE PSI
PROGRAM” (See Figure 2-7).
The baseline pressure has been set in the factory at 100-psi for all wheel positions.
DORAN recommends that all baseline pressures are set to the same pressure levels
recommended by the tire manufacturer. If baseline pressures need to be changed, or a
new sensor is programmed, then follow the procedure below. Otherwise, press “P” once
to proceed to Date and Time Settings.
Figure 2-7
Figure 2-6
Figure 2-6a
