DPM-OTR
Version 1
2019-01-28
7
2. PROGRAMMING THE MONITOR
In order for the monitor to report tire information the user, sensor serial numbers and baseline
pressures for each tire location need to be programmed. This is done by following the steps
below. Note, “black box” products do not have an audible alarm or feedback.
Do not
install sensors until all programming is completed and the monitor is returned to the
normal operation mode.
A.
PROGRAMMING THE SENSOR LOCATION
1)
Ensure that the power is on. Upon first power up, the display will show “
n
SP
which
stands for “No Sensors Programmed”. Note that this message can also appear if
programmed sensors have not transmitted to the monitor. It could take up to 8
minutes for all sensors to transmit their information. The Programming mode will
need to be accessed to add sensors to the monitor. Be sure to leave the sensors off
the valve stems until the programming is completed to facilitate the process.
2)
Press and hold the “P” button for approximately 5 seconds. When the monitor screen
displays the program mode, the “P” button can be
released. All available tire positions will now be
displayed on the screen. See Figure 2-1.
The monitor
can be set up to display a motor home pulling a car or
trailer, or a car / truck pulling a trailer.
Figure 2-1
“P” is used to enter the program
modes. Also used to silence alarms.
“S” is used to lock in selections
during programming. Used to turn
on and off the backlight.
(4) Arrow buttons are used to
navigate the screen and select
values in the program mode
