DPM-OTR
Version 1
2019-01-28
18
V. NORMAL MODE ACCESSORY FUNCTIONS
1. DROP AND HOOK FEATURE
The Drop and Hook feature allows the operator of the vehicle to customize which sets
of tire sensors the monitor displays. This is useful when a trailer or towed car are not
attached to the vehicle and do not need displayed. The following steps are used to adjust
the display configuration:
1)
Press and hold the “Left” and “Rear” arrow
buttons for 3 seconds to enter the Drop and
Hook Programming Mode.
2)
All of the programmed wheel positions will be
displayed (see Figure 5-1).
3)
Use the “Left” and “Right” arrow buttons to cycle
through the display configuration (see Figure 5-2
and 5-3).
4)
When the desired display configuration is
selected, press and hold the “Left” and “Right”
arrow buttons for 5 seconds. This will confirm
the configuration and return the monitor to
Normal Operation mode. Note, when you
change the display configuration it may take up
to 8 minutes for the monitor to receive all of the
sensor transmissions and update the display.
2. System Reset Function
Warning, this will return the monitor to the factory default settings and erase all
programming! Verify that this is desired before proceeding. To return the monitor to factory
default settings, press and hold the “P” button for 30 seconds.
Be sure this is what you want to do before you proceed!
Figure 5-3
Figure 5-2
Figure 5-1
