DPM-OTR
Version 1
2019-01-28
10
The monitor should now be displaying the wheel positions available for Baseline Pressure
adjustment (See Figure 2-8). The text on the screen will
contain different units of measure (PSI, Bar, or kPa)
depending on which pressure unit is selected in the settings
of the monitor. The Baseline Pressure may be set anywhere
from 10 to 188 PSI. Each wheel position can be set with a
different Baseline Pressure if needed.
1)
Using the same controls as sensor serial number programming, use the arrow
buttons navigate to the desired tire position. Press and hold the “S” button for 3
seconds. This will cause the first dash or number to blink (See Figure 2-9). Use the
“Up” and “Down” arrows to adjust the numeric value and the “Left” and “Right” arrows
to change the digit being adjusted. Once the Baseline
Pressure has been set, press and hold the “S” button
for 3 Seconds until the number flashes twice and
audible beeps are heard. (Audible alarm is not
available on the “black box” products)
2)
For values less than 100, the first digit will need to be 0 followed by the two digit
Baseline Pressure value. Example: For a Baseline Pressure of 95 PSI, the value
would be entered as “095”.
3)
If additional Baseline Pressures need changed, use the arrow keys to navigate to the
next position to be programming and repeat step 1. If all Baseline Pressure have
been set, press “P” once to move to the Date and Time Settings. Note, press and
hold “P” for 5 seconds to exit programming mode and return to normal operating
mode at any time.
4)
To set the a global Baseline Pressure, press and hold “S” on any tire position, enter
in the desired global Baseline Pressure, and press “S” and “P” simultaneously for 3
seconds.
Figure 2-8
Figure 2-9
