Maintenance & Adjustment
176
D760.H03E-001.H1907
12. Check the oil level, and fill the oil until it overflows if necessary;
13. After using the new gasket, tighten the oil spill port screw plug.
CAUTION:
1.Please check the oil level below 40ºC temperature.
2.The correct position of the oil surface is at the bottom of the overflow
port, that is, the oil overflow position.
3.Check the oil level after the test run, which is the correct refueling
process, so as to ensure the accurate refueling volume and the split
heat exchanger. Check after the test run for about 5 minutes, to
prevent the heat exchanger idling.
Drain the residual coolant
WARNING:
Touch hot gearbox or engine coolant
may cause burns, please take precau-
tions.
Residual coolant can only be removed when the
temperature sensor is removed
1. Loosen the bolt;
2. Remove the temperature sensor;
3. After draining, use the new O-ring, then
install the temperature sensor back and
tighten the bolts
Tightening torque: 9.5 ± 1 Nm
1. Bolts
2. Temperature sensor
Summary of Contents for DFH4180 Series
Page 2: ......
