DongFeng DFH4180 Series, User Manual

Page: 145 / 251

Fuse box
D760.H03E-001.H1907
135
Cab Tilting
Please refer to the specific configurations of your vehicle.
CAUTION:
Check that the cab door is locked and objects in the cab put in order, so
as to avoid objects falling off during cab tilting, damaging the cab.
Always open the front face shield prior to tilting the cab; otherwise the
shield may be damaged.
Tilting of electric cab
Open the front face shield and keep it
opening during tilting.
1. Cab lift: adjust the reversing handle to the
lifting position, remove the electric lift switch,
stand on the side of the cab, and press the
switch. (or insert rocker, rocker swings back
and forth around the center axis) to achieve
lifting in place.
2. Cab back down: adjust the reversing handle
to the back down position, hold down the
electric lift switch, and replace the electric lift
switch after completion. (or insert a joystick
that swings back and forth around the center
axis) to fall back into place.
3. When the cab is not locked and in position,
the indicator light on the instrument will give
warning
WARNING:
1.Before tilting the cab, it is required to stop the vehicle, shut the engine
down, and shift into neutral, and it is prohibited to tilt the cab on a
slope or do other operations before the cab it tilted in place.
2.During tilting of the cab, ensure that the shield is opened, and there is
no person or objects in front of or around the cab, so as to avoid
accidents.
3.During driving, the reversing handle should be set at the Return
position.
4.During tilting of the cab, the hydraulic locking sensor may make a
tisket sound under normal conditions, and the red tilting display
figure on the instrument panel in the cab will be illuminated; when the
cab is lowered in place, the tisket sound may disappear, at the same
time, the tilting display figure on the instrument panel may disappear;
it is only possible to start the engine and move the vehicle when it is
confirmed that the cab is locked in place.
1. Reversing handle
2. Electric tilting and lifting switch
3. End cap
4. Socket and center axis
5. Control lever
6. Extension lever
7. Electric lift switch (front)