Structure and Operation
22
D760.H03E-001.H1907
Driver seat cushion depth
1. The seat slide rail is in the last position;
2. On the basis of graphic method, adjust
backrest angle to 12 °, this is normal driving
position.
3. On the basis of 1 and 2, the seat cushion
depth shall be measured according to the
requirements of the drawing.
Seat Belts
Driver's and passenger's seat belts
1. To use the seat belt: pull the belt out slowly,
put it between the shoulder and the base of
neck and make it pass through the proper
position of the chest. Then insert the latch
plate into the buckle until a click is heard,
and adjust the belt to your comfort.
2. To unfasten the safety belt: press the button
on the buckle to release the latch plate and
put the belt back slowly.
WARNING:
1.Make sure that the belt is untwisted, clear of hard edges and free from
chemical pollution.
2.The seat belt can be used by one person only. Adult and kid are
prohibited to share one belt.
3.The whole seat belt should be replaced if any component comes into
failure or damage.
4.The seat belt should be replaced if the retractor is blocked.
5.Always adjust the belt length according to the body; otherwise hazard
will be caused.
1. Normal use and
back angle 12° of seat depth mea-
surement
2. Seat cushion depth
3. Measure along the center line of
1. Buckle
2. Latch plate
Summary of Contents for DFH4180 Series
Page 2: ......
