17
Example:
LEVEL
NO
ENTER
LEVEL = cm
Select the required value followed by ENTER.
NOTE:
If the cause for the end of a STEP is a temperature or a level the screen will display the next
message:
WDT = NO
Select the time for the WDT.
Press ENTER and the screen will display:
WDT
=
m
Select time in minutes and press ENTER.
The following message will be displayed:
WDT = s
The input value must be reasonable higher than the load, discharge, or heating time of the water in
the tank.
The screen will ask:
STORE
?
If the replay is STOP the previously programmed step will be overridden, if confirmed with
ENTER, it will be memorised and the beginning of a new step will be indicated with:
START STEP 2
The procedure will be the same as the programming of the first step until completing the cycle in
question.
After programming the last step, and confirming memorizing, the screen will display:
COOLING
?
NO
Press STOP to finish the cycle programming:
The screen will display:
PREWASH
=
?
Suggesting the choice of a new cycle to be programmed.
Press RESET to exit cycle programming.
