21
1) The programme does not exist:
The following message will be displayed on the screen for 2
seconds:
NOT
FOUND
!
then:
C>1
?
Pressing ENTER the screen displays:
C1> PREWASH = ?
By pressing the keys INC and DEC, you can choose the desired type of cycle: Prewash, wash,
rinse, spin and unwind.
For example, if you want to insert wash n.3, first you will have to display a wash pressing INC
until the following message disappears:
C1 > WASH = ?
confirm the selection with ENTER.
At this point the screen will ask for the number:
C1 > WASH = No.
3 is entered followed by ENTER.
Wash n.3 is memorised as the first cycle of the programme.
Successively the screen will ask if you want to program the second cycle, displaying the message:
C2 > ?
Confirming with ENTER the available choice of cycles is repeated with the same modalities
already seen .
It is possible to create programmes freely, with a maximum of 15 cycles, chosen from the existing
cycle menus of the library.
The same cycle can be used more than once in the same programme.
After programming and entering the last cycle, the STOP key is pressed to finish programming.
The screen will display:
STORE
?
Pressing ENTER the programme is memorised, pressing RESET everything will be overridden
back to the initial situation.
NOTE:
If during the choice of a cycle, for example:
C2 > WASH = No 8
and when pressing ENTER the message displayed is:
NOT
FOUND
!
it will mean that wash n.8 does not exist in the library of cycles, and therefore it must be
programmed (see cycles programming) or otherwise a wash with another number must be chosen.
2) The programme already exists:
the following message will be displayed for 2 seconds:
ALREADY
EXISTS
!
then the content for the programme starting from the first cycle will be displayed.
