20
Press INS and for 2 seconds the following message will be displayed:
START STEP X
and then to the question:
COOLING
?
NO
it will require to program the new step with the procedure already described. After having
added one or more new steps to the memory and confirmed their memorizing, press STOP.
d.-
Eliminate one or more existing steps. Press ADVAN, as it has been already described for
the insertion of a new step (point c), and when the message:
ALREADY
EXISTS
!
referring to the step to be eliminated is displayed, press DEL.
The following message will be displayed:
DELETE
?
Press ENTER to erase the step or RESET to override the operation.
After confirming the erasure of the step or steps press STOP to exit.
NOTE:
The system memory allows a maximum of 99 cycles of each type (99 prewashes, 99 washes, etc.).
Each cycle can contain a maximum of 100 steps.
In total up to 400 steps can be programmed.
PROGRAMMING THE UNBALANCE ROUTINE
If during spin an excessive swinging occurs, the machine will stop the running phase and call the
unbalance routine, after this routine, it will start working from the beginning of the cycle where it
was stopped.
The anti swinging routine is programmed with the cycle "Unroll cycle n.99" which cannot be used
in the programme setting.
2
.5.- Programme setting.
Access code 27
With the machine stopped and pressing START and RESET simultaneously the machine waits for
the access code:
No.
?
Entering 27 followed by ENTER you can gain access to the programme setting or modification,
and the screen displays the message:
EDIT PROG. No.
The screen asks you to enter the number of the programme to be edited Replying with the desired
number, from 1 to 30, followed by ENTER, there are two possibilities:
1)
The programme does not exist in the memory and must be created
2)
The programme already exists and can be displayed or modified
