DPC Touch User Manual
11
6.1
Fastening step creation
NOTE:
it is useful to define encoder’s reference point before creating a fastening step. See encoder’s
settings for more information.
While in Job creation screen, tap on FASTENING step button. The Fastening step creation screen will
appear.
Current
field displays the number of position being programmed.
Saved
field displays the total number of saved position in the fastening step being programmed.
Current channels
fields display current values from analog encoders. Only active channels are shown.
Saved channels
fields display saved values from analog encoders. Current values are saved when
Apply button is pressed or when Fastening OK signal is received.
Tolerance
fields display tolerance values for analogue encoders to be applied for each encoder for
the current position. Tolerance values can be automatically detected by using Smart Tolerance
detection feature (please refer to corresponding chapter for more details).
NOTE:
real shapes of tolerance areas are not circular; they depend on the geometry of the
positioning arm being used. To avoid overlapping of tolerance areas of different screws, keep
tolerance values as low as possible.
Approaching area (orange):
Tool is disabled
OK zone (green):
tool can be enabled
Out of position area (red):
Tool is disabled
Screw
