Docomo PRIME series N-01A, Instruction Manual

Page: 64 / 602

62
Voice/Vi
deophone Calls/P
ushTalk
Switching a Voice/Videophone
Call during a Call
z
You can use this function with terminals compatible
with voice call/videophone call switch.
z
You can switch calls only when you are the caller.
z
To switch calls, the receiver needs to set “Ntfy
switch-mode” beforehand.
→
p.81
<Example: To switch a voice call to a videophone
call>
1 In-call screen (p.58)
X
d
(V.phone)
X
“YES”
During switching, a screen appears indicating
that the calls are being switched, and voice
announcement is played.
■ To switch a videophone call to a voice call
X
Videophone in-call screen (p.58)
X
u
(FUNC)
X
“Change to voice”
Making an International Call
<WORLD CALL>
WORLD CALL is a service where you can use your
DOCOMO mobile phone to call overseas.
You applied for “WORLD CALL” when you started to
use FOMA services. (Except if you did not wish to
apply for it.)
z
You can make a call to approximately 240 countries
and regions worldwide.
z
“WORLD CALL” charges are billed with your
monthly FOMA call charges.
z
In addition to directly dialing a phone number, you
can make an international call by adding “+” or
selecting “Int’l call” or “Prefix numbers” from the
function menu of the enter phone number screen or
Phonebook/Redial/Dialed calls/Received calls
detail screen.
z
Services are not available in some billing plans.
N
z
It takes about 5 seconds to switch the calls. Note
that the signal quality may affect the switching
time.
z
You cannot switch calls in the following cases:
• When the other party is holding the call
• When the other party activates Record
message
z
The displayed call duration is reset to 0 second
each time the calls are switched. However, the
total time of the voice and videophone calls is
displayed after the call ends.
Digital communications
charges apply after this
screen appears.
z
Depending on the other party’s communication
conditions or signal quality, you may not be able to
switch the calls and the call may be disconnected.
z
When the call is switched, the first dialed or
received call is stored in the Redial/Dialed calls or
Received calls.
<When switching from voice call to videophone
call>
z
If the caller is using i-mode, i-mode is
disconnected and the call is switched to
videophone.
z
If the other party is using packet communication
(including i-mode), the message “No Switch”
appears and the calls cannot be switched.
z
You cannot switch the calls when “Call Waiting” is
active.
For WORLD CALL, call at general inquiries
provided on the back of the manual.
International videophone calls can be made to 3G
area-compatible overseas handsets by pressing
o
(V.phone) after following the dialing procedure
below.
z
Visit the NTT DOCOMO website for countries
and operators.
z
In some types of the other party, international
videophone is not available or the other party’s
picture on FOMA is distorted.
N