WRM-10P S2 USER’S MANUAL REV 1.0
30
n.
The following screen will be displayed:
Set the LTC or Voltage Regulator tap position to the position indicated on the LCD screen
and press the
[START]
key.
The WRM will continue the test and display the results as in step m.
Repeat steps m
through n
for all “Lower” positions and then through all “Raise” positions.
o.
The following screen will be displayed after the last “Raise” position’s resistance reading
is stored:
Press the
[1]
key (
YES
) to print the test results on the unit's built-in thermal printer.
A typical LTC/voltage regulator test report printout is shown in Figure 9.
p.
The following screen will be displayed:
Press the
[1]
key (
YES
) to save the test record.
q.
The following screen will be displayed:
Press any key to return to the "START-UP" menu.
SHOT NUMBER 003
HAS BEEN SAVED!
SAVE THIS RECORD?
1. YES
2. NO
PRINT RECORD?
1. YES
2. NO
SET TAP TO 2 LOWER
("START" TO CONTINUE)
** XFMR ENERGIZED! **