Digital
Monitoring
Products
CellCom‑LTE Programming and Installation Guide
20
Test Report
Choose
NO
to disable sending these reports to the receiver.
First IP Address
Enter the first (primary) IP address where the communicator sends cell messages. Enter
all 12 digits and leave out the periods. For example, enter IP address 192.168.0.250 as
192168000250. The periods display automatically.
First IP Port
Enter the first IP port number to be used with the first IP address. The IP port identifies the
port used to communicate messages with the communicator. The default IP port setting is
2001
.
Second IP Address
Enter the second IP address where the communicator sends network messages. Enter all
12 digits and leave out the periods. The periods display automatically.
Second IP Port
Enter the second IP port number to be used with the second IP address. The IP port
identifies the port used to communicate messages to and from the communicator. The
default IP Port setting is
2001
.
RECEIVER 2 PROGRAMMING
Set the options for the second receiver that the communicator attempts to contact
when sending reports from the host panel or communicator. The communicator supports
communication with up to two receivers.
Note:
If you select
YES
for any of the receiver 2 options, you must have at least one IP
address programmed in receiver 2 programming. The receiver 2 defaults are set to
NO
.
Alarm Reports
Choose
YES
to enable Abort, Alarm, Alarm Restoral, Alarm Bell Silenced, Ambush, Exit
Error, and System Recently Armed reports to be sent to this receiver.
Choose
NO
to disable sending these reports to the receiver. The default is
NO
.
Supervisory/Trouble Reports
Choose
YES
to enable Supervisory, Trouble, Trouble Restoral, Force Armed, Late to Close,
and Fault reports to be sent to this receiver.
Choose
NO
to disable sending these reports to the receiver. The default is
NO
.
Opening/Closing and User Reports
Choose
YES
to enable Opening/Closing, Schedule and Code Changes, and Bypass reports
by user to be sent to this receiver.
Choose
NO
to disable sending these reports to the receiver. The default is
NO
.
Test Report
Choose
YES
to enable the recall test report from the host panel and/or communicator to
be sent to the receiver.
Choose
NO
to disable sending this report to the receiver. The default is
NO
.
First IP Address
Enter the first (primary) IP address where the communicator sends cell messages. Enter
all 12 digits and leave out the periods. For example, enter IP address 192.168.0.250 as
192168000250. The periods display automatically.
First IP Port
Enter the first IP port number to be used with the first IP address. The IP port identifies the
port used to communicate messages with the panel. The default IP port setting is
2001
.
Second IP Address
Enter the second IP address where the communicator sends network messages. Enter all
12 digits and leave out the periods. The periods display automatically.
Second IP Port
Enter the second IP port number to be used with the second IP address. The IP port
identifies the port used to communicate messages with the panel. The default port is
2001
.
TEST RPT NO
YES
FIRST IP ADDR
000.000.000.000
FIRST IP PORT
2001
SECOND IP ADDR
000.000.000.000
SECOND IP PORT
2001
RECEIVER 2 PROG
ALARM
NO
YES
SPV/TRBL
NO
YES
O/C USER
NO
YE
S
TEST RPT
NO
YES
FIRST IP ADDR
000.000.000.000
FIRST IP PORT
2001
SECOND IP ADDR
000.000.000.000
SECOND IP PORT
2001
Summary of Contents for CellCom LTE Series
Page 4: ......
