revision: 0
FlexxPump 125 (24V)
User Manual
21
EN-
SCHMIERSYSTEME
D I R E C T L U B R I C A T I O N S Y S T E M S
D L S
Emptying time Et = 6
The emptying time of one (1) cartridge is 6 months.
The default settings in the Empty-Time-Mode result in an emptying time (service
life) of 6 months for a full 125 ml lubricant cartridge, provided that the FlexxPump 125
is permanently switched on and no special dispensations have been made. Within
approx. 5.6 hours, the FlexxPump 125 will deliver one donation per stroke (0.15 cm³).
When using a 250ml cartridge, the FlexxPump 125 will deliver a single stroke (0.15cm³)
of the dispenser within approximately 2.8 hours.
Verify that the default settings are appropriate for your application and that the lubri-
cation point is supplied with the correct amount of lubricant per time unit.
If this is the case, you can operate the FlexxPump 125 with the default settings in the
Empty-Time-Mode Et.
If this is
not
the case, change the values for the emptying time t accordingly; see chap-
ter 6.3.10 for an explanation of how to make these changes.
To use FlexxPump 125, it must first be properly mounted and installed and then
switched on. Installation is very simple and described in detail in chapter 5.2; switching
on is described in chapter 6.3.3.
If you order a special version of FlexxPump 125 from the factory, the information
contained in the supplement is authoritative for you!
6.2.2 Default setting operating mode Empty-Time-Mode Et
6.2.3 Default setting operating mode Pulse-Control-Mode PUL
In the Pulse-Control-Mode PUL, the FlexxPump 125 can be integrated into a control
system (PLC) and can be commanded and controlled. Depending on the signals of the
external control (PLC), the FlexxPump 125 will support one or more strokes (one stroke
= 0.15 cm³).
Make sure that your PLC program is appropriate for your application and that the
lubrication point is supplied with the correct amount of lubricant per time unit.
If this is the case, you can operate the FlexxPump 125 in Pulse-Control-Mode PUL.
If this is
not
the case, change your PLC program accordingly.
To use FlexxPump 125, it must first be properly mounted and installed and then
switched on. Installation is very simple and described in detail in chapter 5.2; switching
on is described in chapter 6.3.3.
If you order a special version of FlexxPump 125 from the factory, the information
contained in the supplement is authoritative for you!