Divus OPENDOOR Manual Download Page 20

Page: 20 / 111

DIVUS OPENDOOR manual

which calls all registered clients. Otherwise it’s also possible to call only a single client, by entering e.g. 101 in this
field; only the client 101 will then ring when the ring button is pressed.

DTMF-Code:

This code specifies with which DTMF code the door opener can be activated (normally Relay 1); up

to 4 digits are possible. For being able to recognize the DTMF-Code the OD-Sip Plus must have an ongoing
conversation to another client (for example Videophone client).

Relay mask:

keep the default value „00000000“.

Incoming:

These settings define how to handle incoming calls. If a client calls the OD-Sip Plus for the OD-Sip Plus

it will be an incoming call. Following options are available:

Reject:

the incoming call will be rejected immediately.

Accept:

the incoming call will be accepted immediately.

cheep:

the incoming call will be accepted immediately with a short acoustic signal.

announcement:

the incoming call is accepted immediately and the saved announcement is played to

the other client; so the first thing the calling client hears is the announcement.

annocheep:

the incoming call is accepted immediately with a short acoustic signal and the

saved announcement is played to the calling client; so the first thing the calling client hears is the announcement.

Signalling:

the OD-Sip Plus doesn’t accept the incoming call immediately, but plays an acoustic signal to

acknowledge that there is an incoming call. The call will be accepted when a ring button is pressed; so the OD-
Sip Plus acts like a phone.

Outgoing:

Defines how the OD-Sip Plus handles outgoing calls. The option are the following:

Announcement Off:

When the called client accepts the call, no announcement is played to it.

Announcement On:

When the called client accepts the call the saved announcement is played to the client, so

the first thing a called client hears after accepting the call will be announcement until it is finished and only
afterwards a speech conversion is possible.

Light:

If one of the two relays is configured for function “Light/Camera”, this parameter enables this relay to close

the contact, when the related “Number” is called by the OD-Sip Plus, or when the client with this “Number” (SIP
ID) calls the OD-Sip Plus. It means, that when the defined “Number” (SIP ID), calls the OD-Sip Plus the relay will
be switched on until the call is accepted and during the whole communication, premised this parameter is set to
“On”; same thing happens when the OD-Sip Plus calls a configured number in the phone book (SIP ID), premised
this parameter is set to “On”. The relay will switch off, when the call is dropped after the specified time delay.

Group-ID:

Each „Number“ can be associated to a Group-ID; up to 10 Group-IDs are possible. This settings is only

relevant for call chains. If a call chain is activated and a number of for example Group-ID “3” is called and the
client doesn’t accept the call, then the next number of the same Group-ID is called and so on.

Hint

: „DTMF-Code“ should be set to „2“ and the „Group-ID“ should be set to “None”. All other settings can be

set as whished. Numbers for group calls on the VoIP server of Videophone are 20060101, 20060201, 20060301,
20060401, 20060501, 20060601, 20060701, 20060801, 20060901 and 20061001; a group call makes all clients
ring in the default configuration of Videophone. Detailed information about group calls can be found in the
Videophone configuration guideline.