KR 805
Start up
11.12.08
6-1
6
Installing the machine
Remove any adhesive tapes and remaining packaging.
6.1 Installation
Procedure:
1.
Decide where the machine’s final position will be.
2.
Fit the support surface for the Coffee Grinder. Make sure that the support surface for the machine
is flat and stable. Ideal support height for the machine: 750 mm (30") from the floor.
6.2
Installing the collecting tray
Place the collecting tray (1) onto the two mount-
ing brackets (2).
Fig. 6/1
6.3
Electrical installation
NOTICE
Before connecting the machine to the mains, check whether the local operating voltage, fre-
quency and circuit breakers/fuses match the data shown on the nameplate and with the techni-
cal data in these Operating Instructions. If the data does not match, do not connect the machine
to the mains!
The nameplate is located on the rear of the Coffee Grinder.
•
Also, please note the information in the chapter 3.2 entitled “Technical data” and the circuit diagram.
The later is located in the chapter 12 entitled “Electrical wiring diagrams”.
Coffee Grinder Type KR 805:
The grinders are partially factory-equipped with a 3-wire electric cable with mains plug.
•
Connect the grinder to the mains supply.
•
(Attach the electric cable to a plug which is suitable for the local conditions. The plug must only be
attached by a qualified electrician.)
