- 62 -
0DT828 28/10/2010
USE INSTRUCTIONS
GENERAL SAFETY PRECAUTIONS
This use handbook is an integral and essential part of the product and must be
delivered to the users. Keep the present document and give it to any users coming
after.
This automation is a
“vertical-roll door”
; it must be employed only for its own use.
Any other use is to be considered inappropriate and so dangerous. DITEC refuses all
responsibilities for any damage caused by an improper, wrong and irrational use.
USE PRECAUTIONS
• Do not enter the door action area during moving.
• In case of damage or bad working, turn the main switch off. The operations of
maintenance, adjustment and repair must be carried out by skilled and authorised
staff.
• Each automation has its own “Installation and Maintenance handbook”, reporting the
periodical maintenance plan. Please take care to check all the safety devices.
BUTTONS
• Full opening: the door opens fully. The stroke can be settled by the stop
microswitch.
• Partial opening: the door opens partially, point settled in time by trimmer RP.
• STOP: it causes the complete stop of the door.
• Closing: the door closes fully. The stroke can be settled by the stop
microswitch.
OPTIONAL DS - MANUAL OPERATION
• To raise manually the panel, in case of power lacking or damage, act as follows:
raise the panel on open door position as shown at side.
MAINTENANCE (every 6 months)
INSTALLATION / FITTING
Tighten the fi tting screws of the uprights with the crosspiece
Check the anchoring of the door to the door frame
MOTOR
Check the fi xing of the motor
MAIN SHAFT
Check the good bearing supports fi xing
Lubricate the support bearings
SAFETY DEVICES
Check the good safety bar functioning
Check the good conditions of the rubber profi le of the safety bar
Check the correct operation of the safety photocells
Optional for BASIC fi tting out.
Standard for TOP fi tting out.
Chiude
Close
Fermé
Apre
Open
Ouvre
Chiude
Close
Fermé
Apre
Open
Ouvre
USE INSTRUCTIONS
DET
ACH
AND
DELIVER T
O
THE
CUST
OMER
DITEC S.p.A.
Via Mons. Banfi , 3
21042 Caronno Pertusella (VA) - ITALY
Tel. +39 02 963911 - Fax +39 02 9650314
www.ditec.it - [email protected]
Installatore:
EN
Summary of Contents for Entre Matic ENERGY
Page 11: ...11 0DT828 28 10 2010 6 7 8 9 NO OK 10 11 365...
Page 37: ...37 0DT828 28 10 2010 6 7 8 9 NO OK 10 11 365...
Page 60: ...60 0DT828 28 10 2010...
Page 67: ...67 0DT828 28 10 2010...
