OPERATION
75
CLEANING THE PROCESSOR ROLLS
Every time a safety shear bolt is broken or the PTO has been accidentally stopped while operating, material
accumulated between the cracker rolls and the cutter head must be removed. Follow this cleaning procedure:
1.
Open the top cover (item 1)
2.
Open the cleaning doors (item 2)
3.
Bring the scraper (item 3) down between the cutterhead and the upper roll.
4.
Scrape material out through the cleaning slotted holes (item 2 or 4).
5.
When the cleaning is done, close the top cover and the small cleaning doors. Engage PTO to completely clean the
area between the rolls and the cutterhead. Then, stop everything and check if cleaning is adequate. If not, carry out
the procedure once more.
IMPORTANT: Clean the belt area from any debris to avoid damaging them.
WARNING: Be careful when working inside the cutting chamber. A piece of wood should block the cutting
head in order to prevent any sudden rotation of the knives.
Figure 83 Cleaning the processor rolls
Manual
N
o. F6918E003E v1.2
Summary of Contents for Scorpion 300
