SETUP
46
STEP 3 - FIGURE 51
Remove the LOC double sprocket (item 1), by removing the spring clip (item 2) and washer (item 3). It may
be easier to remove disconnect the chain when removing the 34tooth sprocket.
Figure 51 Double sprocket
STEP 4
Apply anti-seizing lubricant on the shaft and slide in the required sprocket from the table in Figure 48. Set
the washer (item 3) and clip (item 2) back on.
STEP 5
Set the tension back on the chain (item 1) by tightening the rod (item 2). Tighten until the proper tension is
achieved (see Figure 48). Close the main guard.
NOTE:
Three sprockets are included with the harvester: 17, 26 and 34 tooth.
HEADER INSTALLATION
Ensure the harvester and header rest on a flat and level surface. The headers are equipped with a lifting
point (item 1, Figure 52) allowing to use a lift chain and hook for an easy installation.
Figure 52 Header lift point
Manual
N
o. F6918E003E v1.2
Summary of Contents for Scorpion 300
