Dinolift DINO XT II 160, Operating Instructions Manual

Page: 8 / 73

8
Operating instructions • DINO 130T II
1.1. OVERVIEW OF THE UNIT
This unit is a trailer mounted, towable aerial work platform.
This aerial work platform complies with the standard EN280 type 1. Moving the lift by means
of the driving device or by towing is possible only when the lift is in the transport position.
For the operation, the tyres of the lift shall be raised off the ground by means of the hydraulic
outriggers.
The primary power source of the lift is the electric motor. The outriggers and the boom
system are hydraulically powered.
As an option, the lifts can be equipped with a hydraulic driving device.
Consult the chapters “Technical data” and “Structure and functions of the work platform” in
this manual for more detailed information about the lift.
1.2. INTENDED USE OF THE WORK PLATFORM
The aerial work platform is exclusively intended for transferring people and tools to the work
position and acting as a work platform within its permissible load-bearing capacity and reach
(refer to the “Technical Specifications” table and the “Reach Diagram”).
The intended use also covers:
• Following all the instructions in the Operating Instructions
• Performance of the inspections and maintenance operations.
• Observation of the occupational safety regulations and road traffic regulations.
This aerial work platform is NOT insulated, and does not offer protection against contact with
electric current. The aerial work platform must not be used for work on electric systems.
Observe the safety instructions concerning the operating environment, and the restrictions
given in them,
DANGER
WARNING
CAUTION
NOTICE
The operator must receive instructions and consent from the manufacturer for all
such specific work methods or conditions that the manufacturer has not explicitly
defined in the unit's operation and maintenance instructions.