Dinolift DINO XT II 160, Operating Instructions Manual

Page: 43 / 73

43
5.2. OPERATION
Carry out all the daily maintenance routines and inspections in accordance with the
maintenance instructions before operating the lift.
Failure to check the safety devices
may cause a serious injury or make the consequences of an accident worse.
All the faults, observed in the safety devices, must be repaired before the use.
DANGER
WARNING
CAUTION
NOTICE
5.2.1. Operating the lift from the chassis control centre
1. Turn the selector switch Q1 to the position LCB – chassis control
centre.
Piirustuksen numero
VILAKONE OY
Tulostus pvm.
Revisio
Kpl/kone
Ohjetarra, joystick
1
41603606
2. Select the movement speed using the speed selector switch.
If the lift is operated from the control centre LCB, the movement
speed cannot be continually adjusted.
4CB4667
V
3. Drive the boom and the platform using the control levers in the
chassis control centre:
V
- extending and retracting the telescope
- lifting and lowering the boom
- turning the boom
- lifting and lowering the articulated arms
- inclination control of the platform
The levelling system of the platform will automatically keep the
platform level during the movements. As necessary, the position
can be corrected. No persons allowed on the platform during the
adjustment.
The movement will stop as soon as the speed selector switch or the
selector switch for the movement is released.
4. Before starting the operation, lift the platform from the tow-bar and turn it to the side so
that you can lower the boom.
5. Extend the telescope as much as is necessary to ensure that stepping onto the platform
is safe.
Be careful not to damage the light ramps or the tow-bar jockey wheel with the work platform
or the boom!
DANGER
WARNING
CAUTION
NOTICE
DANGER
WARNING
CAUTION
NOTICE
Protect your hearing while using the power unit (option). Sound pressure level at the lower
control centre is 94 dB(A).